Tip's way of changing the configuration of the yoke CRT monitor that can be used in conjunction with the engine on the plane TV.Why must change first? because the value resistansi yoke horizontal monitor is very low (from 0.2 ohm - 0.6 ohm) to the value that could loaded to a series of horizontal deflection , a TV (0.6 ohm - 1.8 ohm). As a result, the burden of transistors Horizontal is a very heavy damage to be caused directly.
This time I try to give a little information about how to change.
You need to provide are: This time I try to give a little information about how to change.
1. CRT monitor with a yoke
2. TV module engine aircraft have facilities for model pinchussion or 21 "more.
3. Transformer yoke "wansonic" (to yoke or SVGA monitor monitor Flat)
4. Electronic tools (solder, tin, etc.).
First you need to do is, wiring attention to the order of the horizontal yoke, there is usually a series of additional monitors at the yoke (a series of dynamic convergence and pincushion series)
. Change the order of the first horizontal row in order to become a parallel way seri.withrelease all the dots connect in each of the horizontal yoke (the vertical is not necessary in the fox). Remove / disconnect all wiring of a series of additional (pincushion) is , take the tip of the end of the cable-spool reels from the core horisontal and you will get four end of the line / cable from the horizontal, the two left and right. with avo meter marks for each coil (coil A and coil B). Connect a one edge of a roller to the left edge of the coil B right.Dan the rest of the end of the two does not go through to the terminal point is that we will use the first .Proses completed, the next immediate resistansi you measure the value of the horizontal yoke do we change This is enough to range between 0.6 - 1.8 ohm meter precision with avo (accurate; recommended AVO meters with digital). if it is enough, CRT ready to use.
Some requirements do you need to note is: Never pull out the components especially the bracelet static CRT convergence in the neck, because if you have changed the day you may need even more to set back a position that has been set at the factory. this very critical for CRT monitor due to a number of pixel more than CRT TV, and for the reasons that I recommend to use the machine TV settings that have facilities pinchussion the stage images. (characteristics: there are two manual trimpot near vertical IC engine TV).
When the size of resistansi horizontal yoke is still too low (on the yoke or yoke monitor SVGA monitor 17 "or over the yoke also monitor Flat). We need to use additional components, the transformer yoke Wansonic (in particular by a manufacturer in wansonic to use by the TV assembly of the plane). transformer is encountered in manyin market with the engine output wansonic tv.
Using a transformer wansonic is as follows:
1.connect blue cable TV to the machine's foot nomor1 transformer also go directly to one of the horizontal yoke.
2. Connect the cable from the red machine to the TV last point (pin6 atau7) from the foot transformer.
3.connect red cable from the yoke to a pin in the transformer wansonic (pin4, 5,6,7) to adjust the width of the image.
Additional information; is recommended to use the machines that have a TV Facilities linearity that the pincushion on the left and right top-down can be arranged as soon as possible.
Congratulations to try and hopefully succeed.
regards,
SolderKnight
0 komentar:
Posting Komentar